I have a linux server and I have bonded two ethernet ports (balance-alb) to ether10 and ether14 on my CRS326 (6.48.1). If I leave ether10 and 14 attached to the bridge, the server can connect fine.
Once I setup bonding on the switch, the server (10.7.10.109) can no longer arp the IP address of the switch (default gateway 10.7.10.1).
I attached ether 10/14 to bond0, mode = balance-alb:
Code: Select all
/interface bonding
add mode=balance-alb mtu=9000 name=bond0 slaves=ether10,ether14
I then added the bond to the bridge:
Code: Select all
/interface bridge vlan
add bridge=bridge1 tagged=ether24 untagged=ether2,ether3,ether4,ether5,ether6,ether7,ether8,ether9,ether11,ether12,ether13,ether15,ether16,ether10,ether14,bond0 vlan-ids=10
I assigned an IP address to the bond (and I was unsure of this part-had no address, tried 109,111 - no change):
Code: Select all
/ip address
add address=10.7.10.109/24 interface=bond0 network=10.7.10.0
At this point, I can't ping the default gateway (10.7.10.1 - which is the switch) from the server. On the server arp -a shows(10.7.10.1) at <incomplete> on bond0.
Would someone with more experience than me (that's everyone else) please offer some assistance if possible?
Thanks very much.