Just recently I bought the R11e-LTE6 kit. Before that I used Tplink Archer router but I wanted better bandwidth in my house.
In short, the device establishes LTE connection and I use winbox to open the device's terminal and can ping internet address such as 8.8.8.8. Few successful replies and then the ping command says timeout and I can't reach Internet anymore.
If I reboot the router same thing repeats again: lte connection gets established, ping is working and few seconds later transitions to timeout, while the whole LTE interfaces says Full functionality, has ISP provided IP address and no session drop is registered.
I am using default configuration, the device itself is plugged into local, dumb switch and all testing is done with valid SIM card with sufficient resources. I also called my ISP to confirm that the router is connected so that I can be sure that their side is cooperating as expected.
Few days later I upgraded to latest Rotuer OS and LTE modem firmware versions.
I need help in troubleshooting to come to the source of the problem. Shouldn't the rotuer be able to work just out of the box like most other consumer products? Am I missing something obvious as I am not accustom to the Mikrotik products? Help, please!
Some info (some masked):
[admin@MikroTik LHG] > /interface lte info lte1 once
pin-status: ok
registration-status: registered
functionality: full
manufacturer: "MikroTik"
model: "R11e-LTE6"
revision: R11e-LTE6_V025
current-operator: HT HR
lac: 1200
current-cellid: 64028686
enb-id: 250112
sector-id: 14
phy-cellid: 364
access-technology: LTE (CA2)
session-uptime: 6m24s
imei: --------
imsi: --------------
uicc: ----------
subscriber-number: "----","----",145
primary-band: B20@15Mhz earfcn: 6375 phy-cellid: 364
ca-band: B3@20Mhz earfcn: 1501 phy-cellid: 364
rsrp: -63dBm
rsrq: -8dB
sinr: 12dB