Hello everyone, I am having a problem when trying to add DHCP client for the ether2
Couldn't add New DHCP Client - can not run on slave interface (6)
OK, I've read I must go to BRIDGE / Ports and remove from there ether2
When I do that, interface hangs for a moment, (I guess the routerboard is rebooting), and then I lose all connectivity to internet, can't get IP address again from routerboard, etc, I have to factory reset the router, and run the quick set again,
ether1 = ISP1
ether2 = ISP2
ether3= empty
ether4=wireless router
ether5=cable goes to my LAN switch
Is there something I doing wrong?
Thank you for the help and welcoming me