Hi All,
I have a brand new paired set of Cube 60G ac radios. While not a Mikrotik expert, this is the 2nd set I have worked with. I was able to easily set up the first set, but I am unable to access the interface on the new set.
I have tried:
1. Set my laptop's Ethernet IP to 192.168.88.10/24 gw 192.168.88.1 and browse to 192.168.88.2. (I am attempting to configure the master)
2. Set my laptop's Ethernet IP to 192.168.88.100/24 gw 192.168.88.1 and browse to 192.168.88.2.
3. Set my laptop's Ethernet IP to 192.168.88.1/24 gw 192.168.88.1 and browse to 192.168.88.2.
4. I tried to access with Winbox. It does not appear in the list, though my two CRS switches do appear.
5. Tried Winbox with only the cube connected directly - No switch between.
6. Factory reset and repeat trying to access with Winbox and browser.
7. The long factory reset, again repeating Winbox and browser.
8. The super long factory reset (20+ seconds) to set into Etherboot mode. Then I tried to install using Netinstall. I followed the guide precisely, using both my laptop and my PC. The cube didn't appear in the Netinstall list on either device.
What have I missed?
My first set I had up and working, using my laptop, in 45 minutes, so I think my methodology is correct.
Can anyone more experienced point me in the right direction?
Thank you,
Darren