For testing purposes, I have created a test setup as attached. From the router terminal I can ping everything, also external nodes such as 8.8.8.8
But from the PC at 70.80.90.0 I can only ping the ether2/lan interface, as well as ether1/wan (192.168.0.10) but nothing beyond that.
However, if I turn NAT on, then it passes traffic. But here is the catch, I need it as a plain router, not a firewall, I need it as a border/edge router for some public IP as shown on page 2 on the attachment.
I also followed the “First time configuration” but I just end up the same place again and again. https://help.mikrotik.com/docs/display/ ... figuration
Routes:
Code: Select all
# DST-ADDRESS PREF-SRC GATEWAY DISTANCE
0 A S 0.0.0.0/0 192.168.0.1 1
1 ADC 70.80.90.0/24 70.80.90.1 ether2 0
2 ADC 192.168.0.0/24 192.168.0.10 ether1 0
Thanks FV