Hi, first post,
I have recently bought two CRS305-1G-4S+IN units, so far they have been working fine, I used them as switches, however this morning both stopped working.
They couldn't be accessed through the Ethernet port, I did try different cables and different computers, to rule out problems.
I proceeded to reset the devices to factory settings, but still the same problem.
From WinBox I can see them in the 'Neighbors' tab, I can see that they have been reset to factory settings because the IP is the default 192.168.88.1, however when I try to 'Connect' with WinBox v3.28 I got the following error: "ERROR: could not connect to 192.168.88.1.
The odd thing is that both of the devices are suffering at the same time of the same issue.
If it helps, what I can see in the 'Neighbors' tab is the correct MAC address, the IP, and then:
Identity: MikroTik
Version: 6.47.9 (long-term)
Board: CR305-1g-4S+
What should I do?
David