Two PWR-Line AP (EU) units with default configuration (no WiFi password). APs used with Huawei LTE router.
To set the WiFi password I log in control panel (WinBox), then -> Wireless -> Security Profiles. Authentification Types: WPA2 PSK; Unicast Ciphers check for aes ccm; Group Ciphers check for aes ccm. -> filling the WPA2 Pre-Shared Key input field. With this done the password is set only for second AP(MikroTik-E13F90). The first AP, which is connected to router is still without password.
Under Quick Set menu only second AP Network Name is visible. I can see both AP under IP menu -> Neighbors. Both with same IP, only last letter for MAC Address is different.
Need help to add the same password for first AP.
Code: Select all
[admin@MikroTik] > /export
# aug/19/2021 15:10:56 by RouterOS 6.48.1
# software id = MD01-6DIM
#
# model = PL7411-2nD
# serial number = BBC70AD0693E
/interface bridge
add admin-mac=MACADDRESS auto-mac=no comment=defconf name=bridge
/interface wireless
set [ find default-name=wlan1 ] band=2ghz-b/g/n channel-width=20/40mhz-XX country=latvia disabled=no frequency=auto installation=indoor mode=ap-bridge ssid=MikroTik-E13F90 \
wireless-protocol=802.11
/interface list
add name=WAN
add name=LAN
/interface wireless security-profiles
set [ find default=yes ] authentication-types=wpa2-psk eap-methods="" mode=dynamic-keys supplicant-identity=MikroTik wpa-pre-shared-key=P4SSWORD wpa2-pre-shared-key=\
P4SSWORD
/interface bridge port
add bridge=bridge comment=defconf interface=ether1
add bridge=bridge comment=defconf interface=pwr-line1
add bridge=bridge comment=defconf interface=wlan1
/interface list member
add interface=ether1 list=WAN
add interface=wlan1 list=LAN
/ip dhcp-client
add comment=defconf disabled=no interface=bridge