I am very new to the Mikrotik RouterOS/SwitchOS. I purchased the Cloud Router Switch CRS317-1G-16S+ and have over 20 hours reading about RouterOS on the Fourms, Wiki.Mikrotik, and from any other source trying to configure the Router without any success. Only processes I have accomplished is getting into the router, upgrading the Firmware & BootOS and nothing else. I have purchased 5 sfp+ modules, and have them plugged into the ports 1, 3, 5, 7, 9. as if I boot into SwitchOS, I can see them under devices, the router see's all the sfp+ modules correctly. Even in SwitchOS, I cannot get any of these to work as LAN devices, and same in RouterOS. Im stuck!
I know there is a huge learning curve but I have tried every configuration I could find on Mikrotik website, and on the internet without any configuration specific to the CRS317-1G-16S+, not even a basic configuration.
I would appreciate help with either pointing me to the correct online help or help with directing me to get this Router/Switch working.
I want to configure the Mikrotik as follows:
a. Replace my ISP's Router with the Mikrotik Router Switch.
a. My ISP is Verizon and they issue Dynamic IP from their network.
b. On the Mikrotik, I wanted 3 VLANS.
a. Vlan 3 with an Network IP of 10.10.0.0/24
b. Vlan 2 with an Network IP of 192.168.1.0/24
c. Vlan 1 with an Network IP of 192.168.88.0/24
c. Setup SFP+1 port as the WAN port.
d. Ether1 port as the Admin/Management Port.
Thanks in advance.