My ISP wants me to log in via PPPoE and gives me the hint that i have to use dynamic IPv6.
So far so good. I used Quick Set to set the CRS328-24P-4S+ as router, connect to the PPPoE Server on ether1 (with success!), host a dhcp-server for 10.0.0.0/24 and activated nat.
After that i the ipv6-stuff as in an tutorials described, i used LAN as pool-name:
Code: Select all
/ipv6 dhcp-client add add-default-route=yes interface=pppoe-out1 pool-name=LAN request=prefix
/ipv6/dhcp-client> print
Columns: INTERFACE, STATUS, REQUEST, PREFIX
# INTERFACE STATUS REQUEST PREFIX
0 pppoe-out1 bound prefix 2a03:b580:XXXX:XXXX::/56, 21h11m35s
Code: Select all
ipv6/ pool/ print
Flags: D - DYNAMIC
Columns: NAME, PREFIX, PREFIX-LENGTH, EXPIRES-AFTER# NAME PREFIX PREFIX-LENGTH EXPIRES-AFTER
0 D LAN 2a03:b580:XXXX:XXXX::/56 64 21h16m
Code: Select all
/ipv6 dhcp-server add address-pool=LAN interface=bridge1 name=server1
Code: Select all
/ipv6/route> print
Flags: D - DYNAMIC; A - ACTIVE; c, d, v, y - COPY; + - ECMP
Columns: DST-ADDRESS, GATEWAY, DISTANCE DST-ADDRESS GATEWAY DISTANCE
DAd+ ::/0 fe80::fe33:42ff:fe23:3007%pppoe-out1 1
DAv+ ::/0 pppoe-out1 1
DAd 2a03:b580:XXXX:XXXX::/56 1
DAc fe80::%ether1/64 ether1 0
DAc fe80::%bridge1/64 bridge1 0
DAc fe80::%pppoe-out1/64 pppoe-out1 0
Code: Select all
DAc 10.0.0.0/24 bridge1
Code: Select all
ipv6/ address/ print
Flags: D - DYNAMIC; G, L - LINK-LOCAL
Columns: ADDRESS, FROM-POOL, INTERFACE, ADVERTISE
# ADDRESS FROM-POOL INTERFACE ADVERTISE
0 DL fe80::a55:31ff:fef7:cd1/64 bridge1 no
1 DL fe80::a55:31ff:fef7:cd0/64 ether1 no
2 DL fe80::1e/64 pppoe-out1 no
3 G 2a03:b580:XXXX:XXXX::/64 LAN bridge1 yes
4 G 2a03:b580:XXXX:XXXX::/64 LAN ether1 yes
I believe i just missed something stupid. I cant ping any ip or host outside my local network from the router itself or any client.