my ISP provide us with some devices, that should be placed "before" router. He suggest to connect uplink cable to switch and from there to his devices and our router. I don´t want to use extra device so my plan is to reconfigure my hAP ac2 like this:
Ethernet ports 1,2,3 will be on "WAN bridge". Ether1 for uplink, Ether2 and 3 for devices from ISP.
Ethernet ports 4,5 and WLAN should be used for LAN.
I use this config:
Code: Select all
# sep/24/2021 16:01:22 by RouterOS 6.47.10
# model = RBD52G-5HacD2HnD
/interface bridge
add name=bridge_wan
/interface list
add comment=defconf name=WAN
add comment=defconf name=LAN
/interface bridge port
add bridge=bridge_wan interface=ether1
add bridge=bridge_wan comment=defconf interface=ether2
add bridge=bridge_wan comment=defconf interface=ether3
add bridge=bridge comment=defconf hw=no interface=ether4
add bridge=bridge comment=defconf hw=no interface=ether5
add bridge=bridge comment=defconf interface=wlan1
add bridge=bridge comment=defconf interface=wlan2
/interface list member
add comment=defconf interface=bridge list=LAN
add comment=defconf interface=bridge_wan list=WAN
/ip dhcp-client
# DHCP client can not run on slave interface!
add disabled=no interface=ether1
Should I move DHCP Client from ether1 to bridge_wan?temporary moving client ether1 from slave to master port, update your config!!!
Will it maintain same functionality?
Is there any better way to solve this problem?
Thank you very much.