Hi,
I am new working with MicroTik, and have a hEX lite to configure.
I started with the default config and made a few changes, here is how it is setup and what it needs to do:
Port 1: WAN DHCP from ISP
Port 2/3/4: get IP addresses from the router DHCP server, 192.168.250.0/24
Port 1-4 are on the same bridge
Port 5: removed it from the bridge, set to static IP
172.16.8.214. This connects to a different network 172.16.8.0/22 where resides a SIP server at 172.16.8.250.
I need to have SIP, RTP and RTSP cross between port 5 and devices on port 2/3/4.
Devices on port 2/3/4 can call each other just fine in peer to peer mode of course, but while those are still in peer to peer, when I connect my laptop on port 5 and give myself 172.16.8.250 and try to call the devices, it does not work/they don’t ring.
I have tried firewall and NAT rules but could not get it to work, for example a device is 192.168.250.20, and I had a rule for dst-nat udp port 5060 from ether5 to that 250.20 address on port 5060 but no luck.
Thanks for any help!