I'd now like to set ether2 as an access port untagged on vlan62, and ether3 as an access port untagged on vlan63.
Traffic on all vlans on ether1 is tagged.
Do I configure this in Bridge, or Interface, or Switch? I tried configuring in Switch, but then the CAP stopped passing traffic.
Thank you
Code: Select all
# nov/10/2022 17:52:13 by RouterOS 7.6
# software id = VL5C-V8UW
#
# model = RB952Ui-5ac2nD
# serial number = 924C096D12E2
/interface bridge
add name=Bridge-vlans
/interface ethernet
set [ find default-name=ether1 ] comment=Uplink
set [ find default-name=ether2 ] comment=esp32
set [ find default-name=ether3 ] comment=cctv
/interface wireless
# managed by CAPsMAN
# channel: 2412/20/gn(8dBm), SSID: wifi350, local forwarding
set [ find default-name=wlan1 ] disabled=no ssid=MikroTik
# managed by CAPsMAN
# channel: 5180/20-Ceee/ac/P(18dBm), SSID: wifi350, local forwarding
set [ find default-name=wlan2 ] disabled=no ssid=MikroTik
/interface vlan
add interface=Bridge-vlans name=vlan99-Management vlan-id=99
/interface wireless security-profiles
set [ find default=yes ] supplicant-identity=MikroTik
/ip hotspot profile
set [ find default=yes ] html-directory=hotspot
/interface bridge port
add bridge=Bridge-vlans interface=ether1 pvid=99
/interface wireless cap
#
set bridge=Bridge-vlans discovery-interfaces=vlan99-Management enabled=yes interfaces=wlan1,wlan2
/ip dhcp-client
add interface=vlan99-Management
/system identity
set name=hAPacLite-Shed
/system ntp client
set enabled=yes
/system ntp client servers
add address=192.168.99.254