My setup is as follows. I have a crappy ADSL modem/router. Its functionality is very limited and I don't want users to connect directly to it. So I want users to connect to the MikroTik's Wi-Fi interface and route the traffic through the ethernet port and through the crappy ADSL modem through to the internet.
The ADSL router's IP is 10.10.10.1 . The MikroTik's ethernet 10.10.10.2 and Wi-Fi 10.20.20.1.
So I connected the MT's ethernet to ADSL router (which is obviously the 10.10.10.0/24 part of the network). When I connect to the Wi-Fi I'm on the 10.20.20.0/24 network and in theory all requests outside this network should be forwarded to 10.10.10.1. This does not happen though. I guess I missed something with my setup.
Here's my MikroTik setup:
Could someone please give me some pointers?
Code: Select all
[admin@MikroTik] interface> print Flags: X - disabled, D - dynamic, R - running # NAME TYPE RX-RATE TX-RATE MTU 0 R eth ether 0 0 1500 1 wlan wlan 0 0 1500 [admin@MikroTik] ip address> print Flags: X - disabled, I - invalid, D - dynamic # ADDRESS NETWORK BROADCAST INTERFACE 0 10.10.10.2/24 10.10.10.0 10.10.10.255 eth 1 10.20.20.1/24 10.20.20.0 10.20.20.255 wlan [admin@MikroTik] ip pool> print # NAME RANGES 0 wlan_ip_pool 10.20.20.100-10.20.20.120 [admin@MikroTik] ip dhcp-server> print detail Flags: X - disabled, I - invalid 0 name="dhcp1" interface=wlan lease-time=3d address-pool=wlan_ip_pool bootp-support=static authoritative=after-2sec-delay [admin@MikroTik] ip route> print detail Flags: X - disabled, A - active, D - dynamic, C - connect, S - static, r - rip, b - bgp, o - ospf 0 ADC dst-address=10.10.10.0/24 pref-src=10.10.10.2 interface=eth scope=10 target-scope=0 1 ADC dst-address=10.20.20.0/24 pref-src=10.20.20.1 interface=wlan scope=200 target-scope=0 2 A S dst-address=0.0.0.0/0 gateway=10.10.10.1 interface=eth gateway-state=reachable scope=255 target-scope=10