I have Mikrotik Panel AP and i need to reset it at 12:00 AM, i write this is script in schedule :
I make it in schedule as well as im set the clock and NTP client but when reboot the RB at 12:00 am all configuration clock and NTP and schedule is lost to default , please help me if possible .


Thanx

Do you run reset or reboot?

/system reboot should not erase any configuration.
NTP client could take some time to synchronize with NTP server.

Dear sergejs,

Thank you for your reply ,

Im make reboot to check it if not lost the config or not , my friend the config for the mikrotik RB400 just A.P:

1- ether1+wlan=bridge
2- Ip address : 192.10.0.11/16 for interface :bridge

Just this is config , Please check it and help , i need to reboot the RB from itself every day .

Thank you again for help me in advance.

Hi ;
Thanx for for this topic it will help alot .
Best regards .
Ahmed

1- ether1+wlan=bridge
2- Ip address : 192.10.0.11/16 for interface :bridge

the following configuration is not erased after /system reboot.

Dear sergejs ,

Thank you , my friend this is config not erase but the i say to you the time and date is reset to default , what the solve for this problem please coz i need reboot the A.P RB433AH every day at time 12am from itself .


I will wait your solve for this issue .

RouterBOARDs don't have batteries and don't keep their clock after reboot. Configure NTP to sync back to the network time after a reboot.

Dear ,

You say , not found config for that , jus reboot the A.P panel Mikrotik manually .

Thank you for any think.

Set NTP client,
/system ntp client.


Use any public NTP server (for example time.nist.gov) to get clock for your router.

my friend , i set all this and work good the A.P Panel Mikrotik but when reboot the router all date and clock is return to default , im apply that and see that .. i think return the date and clock to default coz the A.P don't available rule for NAT coz the A.P just transfer the service not routing i think that , if you want any config , i will be very happy .

my friend , i set all this and work good the A.P Panel Mikrotik but when reboot the router all date and clock is return to default , im apply that and see that .. i think return the date and clock to default coz the A.P don't available rule for NAT coz the A.P just transfer the service not routing i think that , if you want any config , i will be very happy .

Hi ;
Dear the routerboard should access the internet so the NTP client reach the internet and the routerboard will set the clock and date everytime it reboot.
you need to let the AP access the internet to acheive what you need .
with best regards.
Ahmed