Hello all
I have a 450G routerboard. I need to setup my routerboard.Can anyone help me because i've already done it but DHCP server not working on port3-5. but only port2 doing DHCP.

My setup :
Port1 - FTTH - vlan500 pppoe (connected to my BTU modem for internet bridge)
port2-5 - DHCP server

Thanks

Have you configured separate DHCP Server on Each port.

i've already done that.. and it's working if i do sparate DHCP.How do i setup port2-port5 as DHCP ? Do i need to make a slave to port3-port5 ?.. i'm a newbies.. how someone can guide me

Just Make a bridge,
add ether2- ether5 as a bridge port and make DHCP server on Bridge.

A software bridge will not have the same port-to-port forwarding performance as using the switch chip. You do not want to use a software bridge with our simple network setup.

Just do this on ports 3-5. Put the DHCP server on ether2.

When i do this, it's asking for number. What number do i need to set it.


[admin@MikroTik] > /interface ethernet set master-port=ether2
numbers:3-5 (correct right)

And what is the function of slave port to ether-2 ?

A software bridge will not have the same port-to-port forwarding performance as using the switch chip. You do not want to use a software bridge with our simple network setup.

Just do this on ports 3-5.

Code: Select all

/interface ethernet set master-port=ether2

Put the DHCP server on ether2.

Thanks Blake