Hey all, I've been pouring through the documentation and can find steps to accomplish 1 thing but not a document that explains things well enough. I've reached the limit of many home routers (they lag and choke) and talked to a guy that does long wifi backhauls for our local baseball diamond (Go Flying Squirrels!) and he recommended Routerboard.
I have a 433AH with a R52nM intended to be used with 25/25 Fios and beaten to death with torrents, netflix, uploading large files as backup and eventually VPN use for me from work.
So far the steps I was able to put together are:
1 update RouterOS (currently on 4.11) UPDATED, now on 5.4
2 enable ether1 to be DHCP client to get IP and DNS from verizon fios i set dhcp client on ether1
3 give gateway ip 192.168.1.1 in ip address list (in which section should i do this?)
4 bridge ether2 ether3 and wifi (is this right?)
5 enable DHCP server to give out addresses on pool 192.168.1.1/24 to bridge?
6 enable NAT with masquerading on bridge?
So what else am I missing? I figure if I can get enough detail I can piece together a good post with every step so people like me can set this thing up for basic use and only post with decent questions.