I am getting tired of trying to prioritize VoIP whether its through vlan or high priority queues as I just don't know what to do here. I can't seem to find the tos/dscp values for the Mitel 5220's or any other way of prioritizing VoIP on my mikrotik router so instead I am thinking...

Use ether1 for WAN1, ether2 for WAN2. Put them both on their own vlans. Use ether6 for LAN1/2 tying together both WAN connections. Make pfSense box router/gateway on ether6. Then configure pfSense to do QOS, port forwarding and everything else. I'd just want the RB1200 as a bridge.

Anyone have understandable instructions as to how to do this?

I am getting tired of trying to prioritize VoIP whether its through vlan or high priority queues as I just don't know what to do here. I can't seem to find the tos/dscp values for the Mitel 5220's or any other way of prioritizing VoIP on my mikrotik router so instead I am thinking...

Use ether1 for WAN1, ether2 for WAN2. Put them both on their own vlans. Use ether6 for LAN1/2 tying together both WAN connections. Make pfSense box router/gateway on ether6. Then configure pfSense to do QOS, port forwarding and everything else. I'd just want the RB1200 as a bridge.

Anyone have understandable instructions as to how to do this?

If you want a rb1200 as a very expensive bridge, just bring all ports in the bridge and that's it. (Do you also buy F1 race car to do your shopping around the corner?)

Easier said than done. Would you happen to have a short walkthrough available for this?
I just don't want to buy more equipment so this will have to do.

Well, basically said, to prioritize certain traffic you need to set up some processes:
1. Identify the traffic. Can be done by many identifiers like src or dst port, src or dst address, protocol, L7 matcher etc. Voip has certain ports so that is easy.
2. If traffic is identified you have to mark it.
3. Now you have to setup queues that uses these marks to give certain traffic higher priority level than other.

1. and 2. is done by the mangle filter, use either the pre-routing or the forward chain.
3. is done in the Queue section.

This all looks pretty simple, but it is quite some work to really set it up. This is special a field you either have to spend some money to hire someone it to do it for you, or you spend some time to learn and do it yourself.

I suggest you search and read a bit around on this forum and in the MT manual otherwise you'll never understand what you are doing.

First of all identify and mark your VOIP traffic
http://wiki.mikrotik.com/wiki/Manual:IP/Firewall/Mangle
then prioritize it over other trafic
http://wiki.mikrotik.com/wiki/Manual:Queue

HTH,

edit: Rudy was faster than me

Hello

Thanks for posting this. I have just one question. What is the difference between the prerouting and forward chain when setting up mangle to mark packets for voip connection ?

thanks

Jakub