Page 1 of 1
Need Help.. Hotspot feature not working on RB751U-2HnD
Posted: Wed Feb 22, 2012 6:54 pm
by nazree
Hi,
I just bought this router RB751U-2HnD and try configure as hotspot using hotspot wizard and completed but the text are in read, when I connected to the hotspot network, my laptop just connected to internet without popup login page. Please help me cause I already try many times and try other ether port still unsaccesfull. I also read many tutorial found on the net to setup the hotspot but still fail.
Hope someone can help me to solve this problem, I'm newbie here.
Thanks...
This is my winbox screnshoot :
Re: Need Help.. Hotspot feature not working on RB751U-2HnD
Posted: Fri Feb 24, 2012 2:53 pm
by nazree
bump.....
So any sifu can help me ???????
Re: Need Help.. Hotspot feature not working on RB751U-2HnD
Posted: Sat Feb 25, 2012 3:55 pm
by balimore
------
yes,
resetup your hotspot and put on bridge interface will help you.
1. create bridge interface
2. put unwire interface on bridge
3. setup dhcp-hotspot on bridge
Hasbullah.com
-------
bump.....
So any sifu can help me ???????
Re: Need Help.. Hotspot feature not working on RB751U-2HnD
Posted: Wed Mar 14, 2012 11:47 pm
by mardawe
check your wlan1 connection !!!!
Need Help.. Hotspot feature not working on RB751U-2HnD
Posted: Thu Mar 15, 2012 7:40 pm
by scampbell
Make sure wlan1 is not still bridged to ether2.
By default WLAN and ether2 ( plus ether3-5 via switch) are connected in a bridge.
If the post was helpful please give Karma
Re: Need Help.. Hotspot feature not working on RB751U-2HnD
Posted: Thu Mar 15, 2012 8:05 pm
by nazree
Finally I got the solution........after so many try and error
Problem is from routeros default configuration :
#| ether1 is renamed to ether1-gateway
#| DHCP client and masquerade is set on ether1-gateway
#| ether2 is renamed to ether2-master-local and configured as switch master port for ether3-ether5
#| ether2-master-local and wlan1 are bridged - this the culprit..............
#| wireless is set as access point in 2412MHz using both chains and extension channel enabled.
#| IP address 192.168.88.1/24 and DHCP server is set on bridge interface
#| DHCP servers address pool is 192.168.88.10-192.168.88.254
delete the bridge ether2-master-local and wlan1
then configure the hotspot as tutorial..... no more red mark (error)
Re: Need Help.. Hotspot feature not working on RB751U-2HnD
Posted: Thu Mar 15, 2012 8:10 pm
by nazree
Make sure wlan1 is not still bridged to ether2.
By default WLAN and ether2 ( plus ether3-5 via switch) are connected in a bridge.
If the post was helpful please give Karma
Just read your solution, thanks... after I find by my self what is the problem, but it good for me cause i learn many thing about mikrotik.
Thanks again....