Community discussions

 
plisken
Forum Guru
Forum Guru
Topic Author
Posts: 2425
Joined: Sun May 15, 2011 12:24 am
Location: Belgium
Contact:

lcd

Wed Jan 23, 2013 12:19 pm

I want lcd screen shows the graph of ether6 rx/tx, nothing else.
With what command should I set?
 
User avatar
normis
MikroTik Support
MikroTik Support
Posts: 24268
Joined: Fri May 28, 2004 11:04 am
Location: Riga, Latvia

Re: lcd

Wed Jan 23, 2013 12:37 pm

No answer to your question? How to write posts
 
plisken
Forum Guru
Forum Guru
Topic Author
Posts: 2425
Joined: Sun May 15, 2011 12:24 am
Location: Belgium
Contact:

Re: lcd

Wed Jan 23, 2013 12:45 pm

Hé Normis,i have see this wiki, but see nowhere the command, it is unclear to me.
Can you help me further.
Thanks for your reply.
 
User avatar
normis
MikroTik Support
MikroTik Support
Posts: 24268
Joined: Fri May 28, 2004 11:04 am
Location: Riga, Latvia

Re: lcd

Wed Jan 23, 2013 1:03 pm

Simply use your finger to navigate to that Graph screen. It will stay there. No special command is needed.
No answer to your question? How to write posts
 
plisken
Forum Guru
Forum Guru
Topic Author
Posts: 2425
Joined: Sun May 15, 2011 12:24 am
Location: Belgium
Contact:

Re: lcd

Wed Jan 23, 2013 2:47 pm

Thanks Normis, it's a wonderful router board. with a good performance and a lot of possibilities.
And this for a nice cost
 
User avatar
nickshore
Member
Member
Posts: 473
Joined: Thu Mar 03, 2005 4:14 pm
Location: Suffolk, UK.
Contact:

Re: lcd

Wed Jan 23, 2013 3:59 pm

Be nice to be able to set the screen to show something from winbox, eg an interface graph, and completely disable the touchscreen.

Also be nice if scripts could send messages to the LCD

Nick.
Nick Shore MTCNA MTCWE MTCRE MTCINE MTCTCE
LinITX.com - MultiThread Consultants
Get your MikroTik RBs and Training: http://linitx.com/brand/mikrotik
Official UK MikroTik Distributor
IRC chan: #routerboard on irc.z.je (IPv4 and IPv6)

Who is online

Users browsing this forum: No registered users and 37 guests