Maybe this is the right place to place this post ...

after some upgrades and downgrades from 6.06 to 6.13 the problem remains. The eth4 still remains in running.
I haven't found any other discussion about that, so if anyone already solved this problem, please explain me how to.

I had the same problem on CCR1036, but with a firmware upgrade, it seem be working fine.

thanks to anyone that will give me a starting point to solve this issue.

Maybe this is the right place to place this post ...

after some upgrades and downgrades from 6.06 to 6.13 the problem remains. The eth4 still remains in running.
I haven't found any other discussion about that, so if anyone already solved this problem, please explain me how to.

I had the same problem on CCR1036, but with a firmware upgrade, it seem be working fine.

thanks to anyone that will give me a starting point to solve this issue.

/interface ethernet set 0 disable-running-check=no