I am very new to the world of Mikrotik and routing. I have programmed an RB750 as my main router and have it hooked to three AP's via a transparent bridge. Two AP's are MikroTik's with vlan's and the other AP is a Ubiquiti with a vlan. On my RB750, in IP Neighbors, I can see the CPE's on the two MikroTik AP's but the CPE's on the Ubiquiti AP all show up on one line in IP Neighbors. By this I mean they seem to scroll by with each CPE showing on that line for about 5 seconds, then it changes to another CPE or the AP but all on the same one line. Would anyone have any idea what I might have wrong in the programming of the RB750 to cause this? Also I can't seem to Mac Telnet any MikroTik station from within IP Neighbors. Any help or ideas would be appreciated.