I am trying to change the configuration of my RB2011 from using a bridge to using the switch logic.
This should therefore consume less resources as gigabit comms can consume quite a bit of CPU when using a bridge.
How would I achieve this? I have tried to take 2 ports out of the bridge but they cannot communicate with each other. I have confirmed IP addressing is set.
The reason I started using the bridge is because I like the ability to see the traffic stats and I see that recently you can do this without the bridge.
In addition, how would I then link the 2 switches within the unit (port1-5 and port 6-10). Assume I'll need a bridge for that?