Page 1 of 1

NAT Filter

Posted: Thu Jun 19, 2014 4:57 pm
by Redman
Hello,

I just create a NAT for MSTSC connection, It is works but I want to permit only for 1 IP, Where is the settings for it.
Can somebody help me?

Thanks. (CCR1009)

Re: NAT Filter

Posted: Thu Aug 07, 2014 9:17 am
by jayd2k
This thread is pretty old already - if the problem still exists, perhaps you could post your config?

Re: NAT Filter

Posted: Thu Sep 11, 2014 11:30 am
by Redman
It doesn't work yet, I postponed this problem.
Maybe I comeback later with this...

Re: NAT Filter

Posted: Thu Sep 11, 2014 1:12 pm
by cdiedrich
add the desired IP to the src-address of your dst-nat rule.

-Chris

Re: NAT Filter

Posted: Fri Sep 19, 2014 3:42 pm
by Redman
It is working now but i'm not sure if this is the best way,

;;;RDP_MIT
chain=dstnat action=netmap to-adress=102.168.2.50 to-ports=3389 protocol=tcp dst-adress=172.10.10.10 dst-port=3333 log=no log-prefix""