Page 1 of 1

Interface connection with speed limit

Posted: Fri Feb 06, 2015 10:50 am
by Zwodka
Hi All!

A would like to connect 2 or more ethernet interface with speed limit.
For example:
- ether1 -> ether2 : 10Mbps
- ether1 -> ether3 : 20Mbps
- ether2 -> ether1 : 30Mbps
- ether2 -> ether3 : 40Mbps
- ether3 -> ether1 : 50Mbps
- ether3 -> ether2 : 50Mbps
How can I do it?

I've tried:
- all ethernet ports in 1 Switch plus Simple Queue
and
- all ethernet ports in 1 Bridge plus Simple Queue

Simple Queue:
- Target: ether1 / ether2 / ether3
- Dst: ether1 / ether2 / ether3

without any success :-(

Re: Interface connection with speed limit

Posted: Fri Feb 06, 2015 8:25 pm
by hossain2004a
All I know about golden law of queuing ( :D ) you should put the fastest queue in higher priority .

Re: Interface connection with speed limit

Posted: Sat Feb 07, 2015 7:43 pm
by Zwodka
Fastest, lowest, higher, lower ... doesn't matter.
I've tried it with only one Queue ... no success :-((

Re: Interface connection with speed limit

Posted: Sat Feb 07, 2015 9:55 pm
by yancho
When bridging set
/interface bridge settings set use-ip-firewall=yes

Re: Interface connection with speed limit

Posted: Sun Feb 08, 2015 12:10 pm
by Zwodka
When bridging set

Code: Select all
/interface bridge settings set use-ip-firewall=yes

MegaThanx! It works fine! :-)
What if I have more than 1 Bridge? Does it affect all Bridge?

Re: Interface connection with speed limit

Posted: Tue Feb 10, 2015 12:42 pm
by yancho
Yes that is global setting

Re: Interface connection with speed limit

Posted: Tue Feb 10, 2015 4:08 pm
by Netranger21
nice