Hi, i've a little question about load balancing. I've two site; SITE A and SITE B. These sites are connected via two mikrotik dynadish. On both sites there is a routerboard with OSPF up and running and the link was made with two dynadish to increase the bandwidth but currently there is no load balancing. In fact through OSPF the routes are both active but only one link is used while the other remains unused, it is used only in case of failover. Do you have any suggestions? Thanks !
ip route print for example:
30 ADo 10.6.0.31/32 10.58.0.1 110
10.57.0.1
31 ADo 10.6.0.32/32 10.58.0.1 110
10.57.0.1
32 ADo 10.6.0.33/32 10.58.0.1 110
10.57.0.1
33 ADo 10.7.0.0/26 10.58.0.1 110
10.57.0.1
34 ADo 10.7.0.20/32 10.58.0.1 110
10.57.0.1
35 ADo 10.7.0.21/32 10.58.0.1 110
10.57.0.1
36 ADo 10.8.0.0/26 10.58.0.1 110
10.57.0.1
37 ADo 10.8.0.20/32 10.58.0.1 110
10.57.0.1
38 ADo 10.8.0.21/32 10.58.0.1 110
10.57.0.1
39 ADo 10.8.0.22/32 10.58.0.1 110
10.57.0.1
40 ADo 10.8.0.24/32 10.58.0.1 110
10.57.0.1
41 ADo 10.8.0.25/32 10.58.0.1 110
10.57.0.1
42 ADo 10.8.0.26/32 10.58.0.1 110
10.57.0.1
43 ADo 10.8.0.27/32 10.58.0.1 110
10.57.0.1
44 ADo 10.9.0.0/26 10.58.0.1 110