I have created a network between two routers (ospf and mpls), with the ospf all good, but when I activate the mpls in the interfacez, I can access the other router via winbox but it does not show me anything at all and after a while the connection is lost.
Code: Select all
Router 1
/routing ospf area
add area-id=1.0.1.0 instance=ospf0 name=area0
/routing ospf instance
add distribute-default=if-installed-as-type-1 mpls-te-area=area0 mpls-te-router-id=loopback-ospf name=ospf0 redistribute-connected=as-type-1
redistribute-other-ospf=as-type-1 redistribute-static=as-type-1 router-id=10.255.255.1
/routing ospf interface
add interface=ether1 network-type=point-to-point
/routing ospf network
add area=area0 network=2.2.2.0/30
add area=area0 network=10.255.255.1/32
/mpls ldp
set enabled=yes lsr-id=10.255.255.1 transport-address=10.255.255.1
/mpls ldp advertise-filter
add prefix=10.255.255.0/24
add advertise=no prefix=0.0.0.0/24
/mpls ldp interface
add interface=ether1
/mpls traffic-eng interface
add bandwidth=1Gbps interface=ether1
Interfaz R1
MUT 1500
L2 MTU 1592
MPLS MTU 1508
Router2
/routing ospf area
add area-id=1.0.1.0 instance=ospf0 name=area0
/routing ospf instance
add distribute-default=if-installed-as-type-1 mpls-te-area=area0 mpls-te-router-id=loopback-ospf name=ospf0 redistribute-connected=as-type-1 router-id=10.255.255.2
/routing ospf interface
add interface=ether5 network-type=point-to-point
/routing ospf network
add area=area0 network=2.2.2.0/30
add area=area0 network=10.255.255.2/32
/mpls ldp
set enabled=yes hop-limit=0 lsr-id=10.255.255.2 path-vector-limit=0 transport-address=10.255.255.2
/mpls ldp advertise-filter
add prefix=10.255.255.0/24
add advertise=no
/mpls ldp interface
add interface=ether5
/mpls traffic-eng interface
add bandwidth=1Gbps interface=ether5
Interfaz R2
MTU 1500
L2 MTU 1592
MPLS MTU 1508
What am I doing wrong?
