Community discussions

 
ukzerosniper
Member Candidate
Member Candidate
Topic Author
Posts: 126
Joined: Tue Jul 23, 2013 9:20 pm

How to prioritise traffic on Eth1 untill full then use Eth2 as overflow

Mon Jan 28, 2019 4:21 pm

Hi Guys,

Can we take two wan connections, 1 unlimited data and one limited on data and set them up as follows.

Eth1 - Unlimited data - 10Mbps Service
Eth2 - Limited data - 10Mbps Service

When Eth1 reaches 9Mbps of traffic, start sending new connections onto Eth2. When Eth1 is <9Mbps use Eth1.

Can anyone give the advice to achieve this?

I was thinking that TE Tunnels could be a viable option, but I am looking for other simpler alternatives first.
 
Redmor
Member Candidate
Member Candidate
Posts: 248
Joined: Wed May 31, 2017 7:40 pm
Location: Italy

Re: How to prioritise traffic on Eth1 untill full then use Eth2 as overflow

Tue Jan 29, 2019 12:04 am

ImageImage
 
ukzerosniper
Member Candidate
Member Candidate
Topic Author
Posts: 126
Joined: Tue Jul 23, 2013 9:20 pm

Re: How to prioritise traffic on Eth1 untill full then use Eth2 as overflow

Tue Jan 29, 2019 12:07 am

Thanks for the link.

I had a look earlier but couldn’t see a solution :/.

Could you highlight yo me the correct method?

Thanks
 
Redmor
Member Candidate
Member Candidate
Posts: 248
Joined: Wed May 31, 2017 7:40 pm
Location: Italy

Re: How to prioritise traffic on Eth1 untill full then use Eth2 as overflow

Tue Jan 29, 2019 12:25 am

If you can make it work go for TE, I never made it work but I think it's the best solution.
ImageImage

Who is online

Users browsing this forum: No registered users and 8 guests