Hi !

We have CRS328-24P-4S+ for POE up device, and CCR1016-12S-1S+ for Fiber connectivity.
On network are OSPF enabled, so till now we have on AP units (NetMetal) set Ether1 and SFP port to bridge with higher path cost to Ether port, so we have failover if Fiber drop or Ether drop for some reason, device continue working on second port (Ether vs Fiber).
CRS nad CCR are connected on same bridge !
From update to 6.44, log on CRS328 are reporting possible loop on port to CCR, all working but log every minute are reporting loop.

Any suggestions how to make Fiber/Copper failover on different way or something wrong in our config ?