OK please excuse my lack of knowledge, I am very new to routing and have no credentials or fancy titles.
I am trying to connect 2 RB4011's, a branch office and a home office via a standard internet circuit with static IP's from the same ISP. I have followed this guide: https://www.youtube.com/watch?v=qZwPweJrmLU
I was able to get the tunnel to establish under my IPSec policy, however, I cannot ping across the tunnel. I did the NAT rule but I am still not able to get it to work.
Disclosure - I used the quickset to perform the basic setup for the routers, I have a hunch that there are things that the quickset may be the problem. I want to confirm before I dump my configuration and start over with a blank router.
I appreciate any help you can give. A guide that is better might help, I don't mind learning.