Code: Select all
[my router] <-linknetwork1-> [eBGP peer] <- linknetwork2(172.31.23.8/30) -> [my iBGP peer](192.168.13.0/24)
My iBGP peer advertises 192.168.13.0/24 with nexthop linknetwork2. My router marks this as not active.
So, since I have a valid, active route to the next-hop, why doesn't it recursively resolve my iBGP route?
Code: Select all
[admin@core-65001] /ip route> print
Flags: X - disabled, A - active, D - dynamic,
C - connect, S - static, r - rip, b - bgp, o - ospf, m - mme,
B - blackhole, U - unreachable, P - prohibit
# DST-ADDRESS PREF-SRC GATEWAY DISTANCE
...
9 ADb 172.31.23.8/30 172.31.23.1 20
10 Db 172.31.23.8/30 172.31.23.5 200
11 Db 172.31.23.8/30 172.31.23.17 200
...
17 Db 192.168.13.0/24 172.31.23.10 200
So then I'd have to add a static route to that specific network over my linknetwork1 ip. But that defeats the purpose of having a dynamic routing protocol.
So what am I doing wrong, I started reading about scopes, but Im not sure that would apply to this?