Community discussions

MikroTik App
 
cmassey
just joined
Topic Author
Posts: 20
Joined: Fri Nov 08, 2019 8:06 am

MPLS TE not showing traffic

Tue Apr 20, 2021 2:02 pm

I've been trying to get TE with auto bandwidth adjustment to work but I ran into a couple problems.

1. The Traffic Engineering Interface never shows traffic even when there's traffic on it.

2. When using auto bandwidth settings, the rate measured last field works until the first update interval. After that, the reserved bandwidth changes to the rate measured highest as expected. The Active label also switches from explicit to implicit null and the rate measured last no longer works. After the next update interval, it goes to the minimum automatic bandwidth because it doesn't measure anything after the first update.

Router: CCR1036-8G2S+
Firmware: 6.48.2

I was going to leave auto-bandwidth off at first to at least get things working but not being able to see the traffic on each tunnel is pretty difficult to work with. Is things something that is working for others?

Who is online

Users browsing this forum: No registered users and 17 guests