with following scenario , i am not able to transfer data but vpls tunnel is up , but i can transfer data if create eoip tunnel , sending host says host unreachable , ...any help would be appreciated.


host a----ether---router a--->wlan<-----wlan<---router b--->wlan----wlan<--router c--ether--host b

but if use following scenario no issue

host a --ether--router a--->wlan----wlan<---routerb---ether--host b

i played little bit with mtu but no success.

i am using routeros 4.9

regards

wlan or vlan or WAN?
anyway - routes.

wan interface are wlan ...

could you please explain it little bit , to avoid bridging i m using vpls , if u have any current config then please share with me .

but if use following scenario no issue

host a --ether--router a--->wlan----wlan<---routerb---ether--host b

It seems you do not have proper MPLS LSP established between VPLS endpoints (I guess so because it works when endpoints are directly attached). Make sure that you have LDP or TE properly configured on all 3 routers. In case you are still having problems, post MPLS related configuration here.

Thanks Staff ..problem is solved, it was configuration issue as you said.