I want to do a failover (and if is possible, load balacing) of a VPLS acrosso 2 wireless link.
This is my current topology:
/ ---eth1 --link wlan2 .(vpls)...wlan2--eth1---\
\--eth2-- linkl wlan1 ...........wlan2--eth2-----/
There is a VPLS from RB750-01 to RB750-02. It is a LDP VPLS.
I want to do the failover of the VPLS using wlan1 and wlan2 (and maybe load balacing).
I dont want to use ethernet bonding, because I think i will have more control with a L3 failover
For ex. if the wireless link wlna1 does not perform good because interference but is still UP, it has packet loss, the bonding protocol at L2 "thinks" that the link is good, and continue to pass the packets. The bonding protocol detects the wireless link fail only if it isn't UP.
All advices are welcome!