Community discussions

MUM Europe 2020
 
User avatar
Equis
Forum Veteran
Forum Veteran
Topic Author
Posts: 888
Joined: Mon Jun 06, 2005 6:48 am

Nat stopping OSPF working

Fri Jul 26, 2013 6:42 am

Hello

my whole network uses OSPF, runs really well all OK except one router in our office.
It won't fill the routing table on reboot.

I found out if I disable NAT on the router it will then work fine.
I can enable NAT after a min and it will stay working fine till next reboot.

Any Idea's on this?

Thanks

Rhys
 
CelticComms
Forum Guru
Forum Guru
Posts: 1766
Joined: Wed May 02, 2012 5:48 am

Re: Nat stopping OSPF working

Tue Jul 30, 2013 7:29 am

Can you upload the config from the affected system? Also try enabling OSPF debug and see what the log shows during the problem phase.
Interlynx | Networking and Information Security Consultants & Trainers | Email: routerlynx@gmail.com
BGP | EIGRP | OSPF | MPLS | Firewall | VPN | IPsec | Multicast | QOS | IPv4/6 | STP | VLAN | PON | AE | M2M | and more!

Who is online

Users browsing this forum: No registered users and 18 guests