I have the following config on Cisco
ip address 220.127.116.11 255.255.255.252
ip address 18.104.22.168 255.255.255.252
ip address 192.168.1.1 255.255.255.0
Interface 0/0 and 0/1 IPs are for BGP with 2 upstream and Vlan1 is the LAN IP. I have assigned those 3 IPs onto mikrotik individual eth interface.
Interface 0/0 -> Mikrotik ether1-BGP1
Interface 0/1 -> Mikrotik ether2-BGP2
Interface Vlan1 -> Mikrotik ether3-LAN
Cisco BGP config has
network 22.214.171.124 mask 255.255.255.240
network 126.96.36.199 mask 255.255.255.240
I am unable to add 188.8.131.52/30 and 184.108.40.206/30 into Mikrotik->BGP->Networks since those IP Networks are not assigned to any Mikrotik interface.
In this scenario, should i create a bridge on mikrotik with ether1 and ether2 as members and assign 220.127.116.11/30 and 18.104.22.168/30 onto the bridge interface?
The cisco router also has the following config
ip nat inside source static 192.168.1.111 22.214.171.124
ip nat inside source static 192.168.1.112 126.96.36.199
ip nat inside source static 192.168.1.113 188.8.131.52
ip nat inside source static 192.168.1.114 184.108.40.206
I would like to setup the same on Mikrotik using DNAT but Where should i assign the IP address of 4.4.46, 220.127.116.11, 18.104.22.168 and 22.214.171.124 on Mikrotik? The bridge interface?