Hi,
Installation and configuration:
-Imported vmdk 6.44.3 to datastore
-Converted vmdk
-Created new virtual machine with 2 cpu, 4 gbram, 512mb disk as it is on MikroTik site
-Connected disk to ide0
-Network cards vmxnet3
We installed MikroTik CHR 6.44.3 on vmware ESXi 6.5.0.2000 and we have problem with high latency and unresponsivnes when any small traffic gets through MikroTik.
-It install full BGP table in under 30 seconds without problem, but have problem when any internet traffic from client pass through
-Nothing vissible on CPU, just latency goes up over 300ms, and a lot of packet loss, and upload traffic doesnt go higer than 0,5Mbp on 1Gbps internet link connected to it
The same procedure on ESXi 6.0, everything ok, without problem traffic passess few 100Mbps. We tried even exporting ovf from ESXi 6.0 to 6.5, but the same problem on 6.5. We tried changeing hardware version, change the vmxnet3 to e1000 etc, tried only one CPU always the same problem.
MikroTik configuration is the same, the same vlans, everything only vmware version is diffrent.
On 6.5 we have more than 100 VPS, everything ok, only problem with MikroTik, did anybody else encountered similar issue, or have any idea what to try ?