need help!
I installed CHR on proxmox, everything was ok.
the machine is Dell PowerEdge T420, with SFP + intel X520-DA2 board
proxmox identified the intel X520 card when I give the command
#sudo ethtool enp20f0 | grep speed
show 10000Mb / s
but at CHR in ethernet auto negotiation is incomplete, rate unknown
I already took the auto negotiation, but it is the same
I'm licensed free for now, will it be because of the license being free?
on proxmox, I left netowork device virtio on the VM that is CHR,
when I leave E1000, it's 1Gbps in CHR, but it's not 10G
if anyone can help me, I will be very grateful!
sorry my inlges, I'm from Brazil
Thanks