I've been trying to test in GNS3 inter-vlan routing with Router-On-A-Stick over a Bonding interface before deploying to a CCR1009-7G-1C-1S+.
Something is not working, but just in virtualized environments.
The commands I'm testing are just two:
It DOES work in real hardware with version 6.42.12.
Code: Select all
/interface bonding add name=bond mode=802.3ad transmit-hash-policy=layer-2-and-3 slaves=ether2,ether3 /interface vlan add name=vlan10 vlan-id=10 interface=bond
It does NOT work in virtualized scenario, throwing error
I've tried this in Virtualbox and in GNS3(qemu) with the same error.failure: could not set mtu
I've also tested newer versions in GNS3(6.45 and even 7beta) with same error.
In Internet there are videos showing the same commands I use working in GNS3, so i've downloaded an older version (6.34.6) and the commands work ok in GNS3.
Does anyone have a hint about where to look?