Page 1 of 1

Stuck in ipxe with EVE-NG

Posted: Mon Jun 29, 2020 1:29 pm
by myarta
Hello,

I am new to using EVE-NG (Community Edition), but it seems rather powerful. I'd like to try the free level (1Mbps) of the CHR on it for labbing purposes. Following this guide, I downloaded the CHR:

https://www.eve-ng.net/index.php/docume ... ud-router/

When I add a node and try to start it, I'm presented with an IPXE interface that says this:
Booting from ROM...                      
iPXE (PCI 00:04.0) starting execution...ok
iPXE initialising devices...ok



iPXE 1.0.0+ (0600d) -- Open Source Network Boot Firmware -- http://ipxe.org
Features: DNS HTTP iSCSI TFTP AoE ELF MBOOT PXE bzImage Menu PXEXT

net1: 50:00:00:04:00:01 using 82540em on 0000:00:04.0 (open)
  [Link:up, TX:0 TXE:0 RX:0 RXE:0]
Configuring (net1 50:00:00:04:00:01)................. No configuration methods s
ucceeded (http://ipxe.org/040ee119)
No more network devices

Booting from ROM...                      
iPXE (PCI 00:05.0) starting execution...ok
iPXE initialising devices...ok
It just goes through the PXE process for each of the 4 ethernet devices that it's configured with, before giving up and saying:
No more network devices

Booting from Floppy...                   
Boot failed: could not read the boot disk

No bootable device.
Does anyone have experience using CHR with EVE-NG? Or have you run into this issue on other virtualization platforms? Thanks!

Re: Stuck in ipxe with EVE-NG

Posted: Sun Feb 21, 2021 11:48 pm
by caspat
Have you figure it out? I'm on the same boat!