Page 1 of 1

LACP not working (within GNS3)

Posted: Wed Feb 03, 2021 10:33 am
by Shinzon

can anybody please confirm or disagress LACP is not working with CHR and GNS3 or even not working at all? CHR:
/system resource print
uptime: 21h58m18s
version: 6.48 (stable)
build-time: Dec/22/2020 11:20:49
free-memory: 78.4MiB
total-memory: 96.0MiB
cpu: QEMU
cpu-count: 1
cpu-frequency: 2394MHz
cpu-load: 0%
free-hdd-space: 31.7MiB
total-hdd-space: 63.5MiB
write-sect-since-reboot: 512
write-sect-total: 513
architecture-name: x86_64
board-name: CHR
platform: MikroTik
Current bonding config
/interface bonding print
Flags: X - disabled, R - running
0 R name="bond1" mtu=1500 mac-address=0C:47:87:EF:39:00 arp=enabled
arp-timeout=auto slaves=ether1,ether2 mode=802.3ad primary=none
link-monitoring=mii arp-interval=100ms arp-ip-targets=""
mii-interval=100ms down-delay=0ms up-delay=0ms lacp-rate=1sec
transmit-hash-policy=layer-2-and-3 min-links=0
I observed the same behaviour like user in viewtopic.php?t=150013. My remote peer did not see any PDUs ("waiting for LACP response") and I don't see any PDUs sourced by CHR when looking into Wireshark.