I recognized a counting amount of RX overruns on my CRS305-1G-4S+ switch, using a 10gbps DAC cable:
The DAC cable was already replaced but the issue still persists on the same port. Switching the cable to another port also didn't help, the errors will then appear on the new interface.
My CRS305-1G-4S+ is directly connected to a CRS326-24G-2S+ via the affected port. I don't see any issues on the CRS326 side.
The configuration was also checked, Flow Control is disabled and IGMP is enabled right now. Disabling IGMP didn't help, enabling Flow Control caused Pauses instead of the overruns.
Could someone tell me if it is possible to fix the issue? I'm no friends of port errors and would like to solve this.