I have an old model RB260GSP switch in use as optical->gigabit converter with some VLANs defined etc.
Today the power has been cycled and now the switch no longer accepts the password that was configured
before. All the other config appears to be still there (the VLANs still work)
I have powercycled the switch again but it does not resolve the issue.
What can have happened? Is there any password it may have gone (back) to?
I have tried some (empty, admin etc) but I have not succeeded.
I have a previously downloaded config that has the hex value of the password and it corresponds to
the password I know and have tried. (it is just the hex values of the ASCII characters of the password)
But it no longer works...
HELP!