No dice. Plugging in to one of the 1Gb ports with the Asus nic has no issues with resume from sleep/suspend. It's only when going through the S+RJ10My first question is if the issue it with the SFP or the Ethernet per in the computer - it could be either one. Can you plug the Cat-6 into another port on the switch (such as one of the gig-E ports on the switch). Let the computer go to sleep and see if the problem happens in that configuration. Other thing to try is to just unplug the cable, wait a few seconds and plug it back in.
Sent from a $&@#% iPhone using Tapatalk
I don't have to reboot my switch, but I have to sometimes unplug/replug the SFP+ adapter multiple times before it finally works. Another strange thing is that it only negotiates at 5Gbps, not 10, but that's inconsequential at the moment, since the CPU (Xeon-D 1518) in my FreeNAS box can only pump about 2.4Gbps over SMB/NFS, so im not super concerned about that. Given that these modules are ~40$ or so, and are on the APPROVED list for this switch, would be nice to get someone from Mikrotik to comment.I think I'm seeing a very similar problem here.
CRS328-24P-4S+ with an S+RJ10 module connected to a mellanox connectx-3 via another S+RJ10 module.
When I turn off the PC with the mellanox card the S+RJ10 in the CRS328 stops working. In fact, even removing and reseating it will do nothing and that SFP+ port remains dead until I reboot the switch. So I'll move the S+RJ10 around a few times and then I'm forced to reboot the switch because all my SFP+ ports are "dead".
If I unplug the cat-6 between the S+RJ10 modules before turning off the PC, there is no failure.
I'm running ROS 6.44.3.
Exactly. And these adapters have maximum cable length 30 meters at 10GbENegotiated speed highly depends on quality and length of UTP cables used to connect peripherial devices.... Another strange thing is that it only negotiates at 5Gbps, not 10 ...
I may have the same issue: my PC is using an Connect X3 with S+RJ10 to an S+RJ1o on the switch and had problems connecting to the CRS328 too. As could easily move the S+RJ10 on the switch side to my CRS317 I have not bothered to debug it further as that works 100% of the time. Could this be related to the link flapping that the CRS328 has too that Mikrotik has so far not managed to fix?at most my cable is only ~25-30 meters, it goes from one room down a wall into a patch panel. Thats it. the 5/10Gb link doesnt bother me, it's that it doesn't work from suspend. I have to reboot my computer every time.