Hello,
I just bought the Mikrotik CRS 326-24G-2S+ and I want to use it as a layer3 switch for my home network. So, I have created the following vlan 101, 102 and 99. My topology will be like this,
1). I will use ether1 for my uplink from router.
2). For ether 3, 4 and 5, I want to use them trunk links which will go to my Cisco SF 300-48P switches.
3). For ether 6 and 7, I will be used as access ports and for ether24 (which will be used as my MGMT Port).
I just searched on Mikrotik wiki and did the inter-vlan routing according to this link (https://wiki.mikrotik.com/wiki/Manual:C ... s_switches). But I can't even ping to my GW (vlan 99 MGMT) from my access port (ether24) which is directly connect to my PC. I also tested from other access ports. The result was the same. This is my script on my CRS.