Community discussions

 
anav
Forum Guru
Forum Guru
Topic Author
Posts: 3122
Joined: Sun Feb 18, 2018 11:28 pm
Location: Nova Scotia, Canada

Firmware Version Changes to 2.0p

Mon Oct 21, 2019 4:05 pm

Manually Upgraded to 2.10 last week and it upgraded and now states version 2.0p, which is not 2.10???
newer 260gs model.

What the heck is 2.0p ?????
I tried manually loading 2.10 again but still stuck on 2.0p?
Afraid to upgrade my other unit from 2.9

Any advice welcome.
I'd rather manage rats than software. Follow my advice at your own risk! (Sob & mkx forced me to write that!)
 
Kevo
Frequent Visitor
Frequent Visitor
Posts: 55
Joined: Wed Oct 12, 2011 1:38 am

Re: Firmware Version Changes to 2.0p

Mon Nov 04, 2019 1:07 am

I had the same thing happen on one of our switches. Loaded the upgrade through the web interface and when the switch rebooted it had downgraded to 2.0p which I think was the factory installed firmware perhaps. I did the upgrade again through the web interface and after it rebooted it did come up with the 2.10 firmware. It seems to be fine after this, so I think it's OK to just run the upgrade again. I'm not sure if there was some other piece of firmware that needed to get upgraded first before it could accept the newer release or if it was just a glitch with the update code in my previous firmware, but it didn't seem to have any issues upgrading from the 2.0p version.
 
anav
Forum Guru
Forum Guru
Topic Author
Posts: 3122
Joined: Sun Feb 18, 2018 11:28 pm
Location: Nova Scotia, Canada

Re: Firmware Version Changes to 2.0p

Wed Nov 06, 2019 4:30 pm

Thanks Kevo I tried like 5 times with no luck. Just afraid to brick the switch.
i will try again today, maybe the 260GS likes my electrons today.... finicky POS.
I'd rather manage rats than software. Follow my advice at your own risk! (Sob & mkx forced me to write that!)

Who is online

Users browsing this forum: No registered users and 2 guests