Hi,
I setup a CSS326 to connect my home LAN via 1GB Ethernet and NAS via SFP+.
All home connectivity works without problems but I am unable to connect the nas via SFP+.
Practically I have link up for 1-2 seconds and then it goes down. Tx and Rx power values are right at both end. I see some kbytes through the link, both Tx and Rx, on the stats page.
At this stage, to not introduce variables, I am always using default configuration of the switch with all ports speaking to any port and port 1 ethernet connected to home router.
SwOS was at 2.9 level. I also tried to upgrade to 2.10 without success.
1) Do you have any hints?
2) Is there anything specific to configure at SwOS level to have SFP+ link up?
3) I am using FiberStore module "Cisco SFP-10G-SR Compatible". This adopt the same Finisar code of Mikrotik. Is there anybody using these modules for Mikrotik devices?
Thanks in advance for any help
Regards