Community discussions

MikroTik App
 
Paolo46
just joined
Topic Author
Posts: 5
Joined: Tue Jan 07, 2020 6:08 pm

CSS326 10GB connectivity problem

Tue Jan 07, 2020 6:35 pm

Hi,

I setup a CSS326 to connect my home LAN via 1GB Ethernet and NAS via SFP+.
All home connectivity works without problems but I am unable to connect the nas via SFP+.
Practically I have link up for 1-2 seconds and then it goes down. Tx and Rx power values are right at both end. I see some kbytes through the link, both Tx and Rx, on the stats page.

At this stage, to not introduce variables, I am always using default configuration of the switch with all ports speaking to any port and port 1 ethernet connected to home router.
SwOS was at 2.9 level. I also tried to upgrade to 2.10 without success.

1) Do you have any hints?
2) Is there anything specific to configure at SwOS level to have SFP+ link up?
3) I am using FiberStore module "Cisco SFP-10G-SR Compatible". This adopt the same Finisar code of Mikrotik. Is there anybody using these modules for Mikrotik devices?

Thanks in advance for any help

Regards
You do not have the required permissions to view the files attached to this post.

Who is online

Users browsing this forum: No registered users and 14 guests