Hi mkx, thanks for your answer.
Indeed, my problem is about implementation, i try this config:
Port1 - Trunk port (to router) - VLAN1
Port2 - VLAN1
Ports 3-4-5 - VLAN20
So, when i create the VLAN20 and assign to ports 3-4-5 i try various configurations on that ports (leave as is, always strip), port1 remains not a member.
But when i check the connectivity, i cannot see the 192.168.1.1 (router) from 3-4-5.
I try too to put strict on VLAN tab to ports 3-4-5 with same results.
Here you can see 2 screenshots about VLAN/VLANS tabs. Forgot the configuration now applied, i try a lot of combinations
Hope anyone can help, thanks
You do not have the required permissions to view the files attached to this post.