I have a CSS106-1G-4P-1S with wAP ac connected to it.
The switch shows that the speed is changing sometimes to even as low as 10mb, usually to 100mb and when I reset it, it might negotiate it back to 1000mb.
I just opened the web interface, I see that it is 100mb again.
So I check the wAP ac via SSH and it shows:
Code: Select all
/interface ethernet monitor 0
name: ether1
status: link-ok
auto-negotiation: done
rate: 100Mbps
full-duplex: yes
tx-flow-control: no
rx-flow-control: no
advertising: 10M-half,10M-full,100M-half,100M-full,1000M-half,1000M-full
link-partner-advertising: 10M-half,10M-full,100M-half,100M-full
I enable "auto negotiate" again and it negotiates it back to 1000mbps.
And wAP ac shows:
Code: Select all
/interface ethernet monitor 0
name: ether1
status: link-ok
auto-negotiation: done
rate: 1Gbps
full-duplex: yes
tx-flow-control: no
rx-flow-control: no
advertising: 10M-half,10M-full,100M-half,100M-full,1000M-half,1000M-full
link-partner-advertising: 10M-half,10M-full,100M-half,100M-full,1000M-full
So, what's going on here?