Page 1 of 1

RX Overruns with SwOS 2.13

Posted: Tue May 18, 2021 8:23 pm
by Eldowin
Hello,

I recognized a counting amount of RX overruns on my CRS305-1G-4S+ switch, using a 10gbps DAC cable:
Image

The DAC cable was already replaced but the issue still persists on the same port. Switching the cable to another port also didn't help, the errors will then appear on the new interface.
My CRS305-1G-4S+ is directly connected to a CRS326-24G-2S+ via the affected port. I don't see any issues on the CRS326 side.

The configuration was also checked, Flow Control is disabled and IGMP is enabled right now. Disabling IGMP didn't help, enabling Flow Control caused Pauses instead of the overruns.

Could someone tell me if it is possible to fix the issue? I'm no friends of port errors and would like to solve this.

Best regards

Re: RX Overruns with SwOS 2.13

Posted: Wed May 19, 2021 12:55 am
by Eldowin
It seems I can reproduce the issue:

Only when 10Mbit/s or 100Mbit/s Clients are connected to my CRS305-1G-4S+ switch, the switch uplink port counts RX overruns. As soon as I disable the client ports with 10/100 Mbit/s, no RX overruns are shown anymore.

This only affects my CRS305-1G-4S+ switch, 10/100 Mbit/s clients connected to my CRS326-24G-2S+ are not bringing up the issue.

Mikrotik should check if following combination produces RX overruns:
CRS305-1G-4S+
SwOS 2.13
10/100 Mbit/s downlink to clients

Best regards

Re: RX Overruns with SwOS 2.13

Posted: Wed May 19, 2021 12:30 pm
by EdPa
Thanks, the same thing is happening in our labs. Hope to fix it upcoming SwOS releases.